The XPro M65 by SmokTech is the upgraded version of the XPro M50. It is a powerful, yet compact, Variable Wattage box mod. It allows you to easily adjust wattage between 6-65W in 0.1W increments. This mod is made of high-quality aluminum and zinc alloys and feels great in the hand - the XPro M65 is only a little over 10mm taller than the tiny Eleaf iStick!
The XPro M65 features a spring-loaded 510 connection, ensuring that any atomizer you put on it will fit flush. Please note: Although the 510 pin appears adjustable, we do not recommend manually adjusting it. The pin is connected to wiring inside the device and manually adjusting it may result in damaging the mod. Each M65 also comes with an eGo-510 adapter, so you can easily use eGo threaded atomizers with this device. With up to 65W of power, this APV is easily able to run a wide variety of devices, from Clearomizers and Clearomizer Tanks to Rebuildable Atomizers (RBA/RDA).
The XPro M65 is very easy to operate and features an easy to read OLED screen: simply press the "+" and "-" buttons to achieve your preferred power settings. The OLED screen displays your watt/volt output, atomizer resistance, and battery life at a glance. The device can be Locked to prevent misfires. In addition, the XPro M65 can be used in Mechanical mode, allowing you to harness your battery's full voltage output.
This unit uses a single flat top High Drain 18650 IMR battery. We recommend only running High Drain IMR batteries in this device. To insert the battery, use the included allen key to unscrew the allen screws from the bottom plate. Remove the plate, insert your battery positive end first, and screw the bottom plate back on. When battery power is low, please replace with a fresh battery OR use the included Micro USB charger to charge your battery via the Micro USB port located at the bottom of the device. You can also charge your battery separately with a Li-Ion battery charger - we recommend this method, as your battery will charge much faster.
* Please note that the XPro M65 is SmokTech's UPGRADED version of their XPro M50: it is the same unit, with an UPGRADED chip and Pass-through capability. Therefore, some units will arrive with "XPro M50" printed on the unit, but will have an UPGRADED chip inside, allowing you to go up to 65W and use as Pass-through.
|Variable Wattage||from 6.0 - 65.0 W in 0.1W increments|
|Minimum atomizer resistance||0.2 ohms|
|Maximum atomizer resistance||4.0 ohms|
|Spring-loaded 510 pin|
|Short Circuit Protection||In the event of a short circuit, the device will cease output|
|Low Voltage Protection||OLED screen will display "WEAK BATTERY" when battery voltage is lower than 3.4V. Please charge your battery or replace with a new one.|
|Excessive Temperature Protection||OLED screen will display "COOL DOWN" if the internal board temperature becomes excessive. Please wait and allow the device to cool down before using again|
|1x||XPro M65 (Upgraded M50)|
|1x||Micro USB Charge Cable|
|4x||Spare allen screws|